For the inboard/outboard configuration, other wise known as a I/O configuration:
Removal of the lower dive unit as an entire unit. Grease the drive shaft spline, grease and check drive shaft u-joints, check for water and oil in the drive shaft bellows, check bellows for damage, check drive shaft bearing, grease bearing, check housing gaskets & o'rings.
Drain gear lube from drive housing and gear housing, re-fill with high performance Mercury gear lube.
Stabilize fuel.
Grease trailer wheel bearings.
Change engine oil and filter.
Run motor until normal operating temperature is achieved. Drain the motor of all water, flush motor with coolant if necessary.
Lubricate necessary moving parts at the motor.
Inboard boats
Stabilize fuel.
Grease trailer wheel bearings.
Change engine oil and filter.
Check transmission fluid change if necessary.
Check under water running gear.
Run motor until normal operating temperature is achieved. Drain the motor of all water, flush motor with coolant if necessary.
Lubricate necessary moving parts at the motor.